Do I need a special knife to make sushi at home?

Short answer: No: you don’t need a special sushi knife to make maki rolls, hand rolls or nigiri at home; a long, very sharp knife and a damp cloth will do. A yanagiba, the long single-bevel slicer used by sushi chefs, is only worth buying if you regularly slice raw fish for sashimi or nigiri, where it gives the cleanest cut in a single stroke.

Key takeaways

  • Do you need a sushi knife for rolls? No: sharpness matters more than shape. Wet the blade, cut with long strokes and wipe between cuts.
  • A yanagiba is a long, single-bevel knife that slices raw fish in one pull; right- and left-handed versions are different knives.
  • Beginners can slice sashimi with a double-bevel sujihiki or gyuto before committing to a single bevel.
  • For a home board, 240mm is the easiest all-round yanagiba length; professionals usually go longer.
  • The fish matters more than the knife: buy fish your fishmonger confirms is suitable for eating raw.

What is a sushi knife?

A “sushi knife” usually means a yanagiba (柳刃, “willow blade”): a long, narrow knife made for slicing raw fish for sashimi and nigiri. Its length lets you cut each slice in one smooth pull from heel to tip, so the fish is never sawn back and forth and the cut surface stays clean. Professional yanagiba are generally 270–330mm long, while 210–240mm versions are easier to handle on a home board.

Traditional yanagiba are single-bevel: one side is sharpened and the other is flat or slightly hollow. That gives a very fine edge but makes the knife handed, so a right-handed yanagiba won’t cut properly in the left hand, and left-handed cooks need a left-handed version (see left-handed Japanese knives). Single-bevel edges also need their own sharpening technique.

You may also see two regional relatives: the takohiki, a lighter, flatter, square-tipped variant from Tokyo, and the fuguhiki, a thinner, round-tipped variant named after fugu (pufferfish). The other classic fish knife, the deba, is a thick single-bevel blade for breaking down whole fish rather than slicing them (see what a deba knife is used for).

What makes a knife good for sushi?

Whatever it is called, a knife that cuts sushi well has three things:

  • Length: enough blade to finish each slice in one stroke, without sawing.
  • A very sharp edge: a dull edge crushes rice, tears nori and leaves raw fish ragged.
  • A thin blade: less drag through soft fish and sticky rice.

The label matters far less. A “sushi knife” that isn’t sharp will do a worse job than a freshly sharpened gyuto, and a damascus pattern or a matching set won’t change how the fish is cut.

Do you need a sushi knife for maki rolls and nigiri?

Not for rolls. Maki and futomaki need a sharp edge more than a particular shape, because a dull blade squashes the rice and tears the nori. Any long, sharp knife works, whether it’s a gyuto, sujihiki or santoku. To cut a roll cleanly:

  1. Start with a freshly sharpened knife.
  2. Wipe the blade with a damp cloth so the rice doesn’t stick.
  3. Cut the roll in half with a long, gentle stroke, letting the length of the blade do the work rather than pressing down.
  4. Wipe the blade again, line up the halves and cut them into equal pieces.
  5. Re-wet and wipe the blade between every cut.

For nigiri, the knife only matters when you slice the topping. That is where a yanagiba or a long slicer earns its keep.

How do you slice fish for sashimi and nigiri?

The technique is the same with a yanagiba, a sujihiki or a long gyuto:

  1. Start with a neat, well-chilled block of fish, trimmed of skin, sinew and any dark bloodline.
  2. Look for the grain (the lines running through the flesh) and plan to cut across it.
  3. Rest the heel of the blade on the far edge of the fish.
  4. Draw the knife towards you in one long, smooth stroke, using the full length of the blade and almost no downward pressure. Don’t saw.
  5. Move the slice aside with the blade, then wipe the knife with a damp cloth before the next cut.

For sashimi, cut straight down for neat, rectangular slices (hira-zukuri). For nigiri toppings and delicate white fish, angle the blade to cut thinner, wider slices (sogi-zukuri).

Yanagiba, sujihiki or gyuto: which is best for home sushi?

Knife Bevel Best for Learning curve
Yanagiba Single Sashimi, nigiri toppings and thin slices of raw fish Higher: needs care and single-bevel sharpening
Sujihiki (slicer) Double Sashimi, plus roast meats and other long slicing jobs Low: sharpen like any double-bevel knife
Gyuto Double Rolls, everyday prep and occasional sashimi Lowest: one knife for everything
Deba Single Breaking down whole fish Higher: a specialist fish-butchery knife

If you’re new to single bevel, a long double-bevel slicer such as the Tojiro DP VG10 Slicer lets you practise long pull cuts without learning a new sharpening technique. Our guide to sujihiki vs yanagiba compares the two in more detail.

What size yanagiba should I buy?

  • 210mm: fits a small board and suits small fish and occasional use.
  • 240mm: our pick for most home cooks; long enough to slice a typical fillet in one stroke, and still manageable on a domestic board.
  • 270–300mm: professional lengths for large fillets and long, unbroken strokes; you’ll want a big board and some practice.

Our JKC Sushi Yanagiba comes in 210, 240 and 300mm.

Budget or traditional yanagiba?

The JKC Sushi Yanagiba is an affordable way into single-bevel slicing. It is made from MoV stainless steel at HRC 58±1, so it’s forgiving and easy to look after, and it includes one free sharpening. It belongs to our JKC Sushi collection.

Step up to a traditional knife such as the Sakai Traditional Yanagiba or Suisin T Yanagiba when you slice fish often and are ready to maintain a single bevel on whetstones. Check each knife’s specification: traditional knives often use carbon steel, which must be dried straight after use.

What else do you need to make sushi at home?

Beyond a sharp knife, a short list covers most home sushi:

Is raw fish safe for homemade sushi?

The knife is the easy part; the fish is what matters. Food Standards Agency guidance requires food businesses in England, Wales and Northern Ireland to freeze fish intended to be eaten raw, such as sushi and sashimi, to –20°C for at least 24 hours or –35°C for at least 15 hours to kill parasites. Some farmed fish, such as Atlantic salmon reared under strict conditions, are exempt.

The FSA says a home freezer should be around –18°C, so don’t count on yours to do the same job. Instead:

  • tell your fishmonger you’re making sushi, and buy fish they confirm is suitable for eating raw;
  • keep it in the fridge, which the FSA says should be set between 0 and 5°C, on the bottom shelf so it can’t drip onto other food, and use it quickly;
  • use separate boards for raw fish and ready-to-eat food, and wash knives and boards straight after use;
  • if you’re pregnant, follow NHS advice to avoid sushi made with raw fish, even if it has been frozen, and raw shellfish. Sushi made with cooked fish or cooked shellfish is fine.

This is general food-safety information, not medical advice. Follow your fishmonger’s guidance and current FSA and NHS advice.

How do you look after a sushi knife?

  • Wipe the blade as you work and dry it completely straight after use; carbon-steel yanagiba will rust or stain if left wet.
  • Wash it by hand, never in the dishwasher.
  • Protect the long edge and fine tip with a sheath, such as our sheath cover for slicers and yanagiba up to 310mm.
  • Keep it away from bones, fish heads and frozen fish: that’s deba work, and a thin edge will chip.
  • Sharpen the bevelled side on whetstones, following its angle, then remove the burr on the flat back with light, flat strokes (see how to sharpen on a whetstone), or let us do it for you.

Which should you choose?

  • Rolls and the odd nigiri: the gyuto or santoku you already own, freshly sharpened.
  • Occasional sashimi, no new skills: a double-bevel sujihiki such as the Tojiro DP VG10 Slicer.
  • Your first yanagiba: the JKC Sushi Yanagiba in 240mm.
  • Regular sashimi: a traditional Sakai or Suisin yanagiba.
  • Whole fish: add a deba, such as the Sakai Traditional Deba.

Browse our full range of sushi and fish knives, or all our traditional single-bevel knives.

How Japanese Knife Company can help

Learn the techniques hands-on in our private sushi-making class at our Baker Street shop. It runs for 2.5 hours, is tailored to you and covers sushi rice, fish preparation, nigiri and maki, and you’re welcome to bring your own knives (see our sushi-making classes). We sharpen single-bevel knives such as yanagiba and deba at all five London shops, at £2.25 per inch for home cooks, or by post through our sharpening and repair service. The first sharpening is free on every knife bought from us, and you can try knives with guidance in our shops before you choose (shop details).

Related questions

Sources

Reviewed by the Japanese Knife Company team, October 2026.

0
26